How To Use Single Tank Ultrasonic Cleaning Machine, What Should Be Paid Attention To?

Single tank ultrasonic cleaning machine is the use of cavitation doubling or more than a dozen sales to improve the cleaning effect. When the liquid is put into the cleaning machine, after the application, because the ultrasonic wave in the cleaning liquid is a kind of density and density, the high frequency wave of radiation propagation, so that the liquid high-speed reciprocating vibration. In the negative pressure area of the vibration due to the surrounding liquid to supplement, countless small vacuum bubble formation, and in positive pressure area, tiny air bubbles suddenly closed, under pressure in the process of closing due to collision between liquid have a powerful shock waves can amount to thousands of atmospheres of instantaneous high pressure formation, effect on the cleaning of the workpiece. The grease and impurities adsorbed on the workpiece are rapidly separated from the workpiece under the action of continuous instantaneous high pressure. Thus achieving the purpose of cleanliness.

The use of single tank ultrasonic cleaning machine:

1. Put the items to be cleaned into the cleaning basket of the single tank ultrasonic cleaning machine, and then put the cleaning basket into the cleaning tank. Do not put the items directly into the ultrasonic cleaning tank to avoid damaging the equipment and cleaning effect.

2. According to different products or cleaning effects, pour cleaning liquid, water or aqueous solution into the mixture proportionally. The water level shall not be lower than 60mm and the water level shall not exceed 80mm.

3. Connect to the three-core socket of 220V/50Hz power supply and switch on the ultrasonic power supply.

4. Open the switch button of the single tank ultrasonic cleaning machine, and the green switch shows normal operation.

5. According to the ultrasound cleaning requirements of the articles, open the temperature control of the ultrasonic cleaning machine to adjust the temperature.

6. Temperature indicator off the heater will stop working if it meets the required requirements. If it is lower than the set temperature, the heater will continue to heat automatically.

7. When the heating temperature reaches the cleaning requirements, start the cleaning timer and set the working time of the timer according to the cleaning requirements.

8. General items cleaning in 10 minutes to 20 minutes, for difficult to clean the workpiece, can be appropriately extended cleaning time, to ensure the cleaning effect.

9 timer position can be adjusted in 1-20min, can also be adjusted in the normal position. General cleaning in 10~20min, for particularly difficult cleaning parts, can be appropriately extended cleaning time.

10. After cleaning, remove the basket from the tank and wash it with warm water or rinse in another tank with warm water and no solvent.

11. Items should be dried, stored and assembled after cleaning.

Notes for single tank industrial ultrasonic cleaner:

To prolong the service life, it is recommended to put the device in a ventilated and dry area, and the fan hole at the rear of the ultrasonic generator should be cleaned regularly. The generator has air vents on all sides to make the air flow unimpeded.

1. The ultrasonic cleaning tank must be put into liquid before it can start working. The water level is > 100mm (bottom vibration type) and placed horizontally.

2. When cleaning the cylinder at normal temperature, do not directly inject high temperature liquid into the cylinder, so as not to cause the loosening of the transducer and affect the normal use of the machine.

3. When the cleaning liquid needs to be replaced due to pollution, do not inject low-temperature liquid directly into the high-temperature cylinder, which can also lead to the transducer falling off. At the same time, the heater switch should be turned off, so as not to damage the heater because there is no liquid in the tank.

4, check the ultrasonic transducer regularly, do not make it damp and impact, so as not to cause unnecessary losses. Turn off the main ultrasonic generator power supply after use. Do not immediately restart after the shutdown, the gap time should be more than 1 minute.