Key Points For Maintenance Of Ultrasonic Cleaning Machine

During the cleaning process, everyone should pay attention to many places, especially it is strictly prohibited to splash conductive liquids (such as water) into the air inlet at the top of the ultrasonic control cabinet, otherwise it will cause serious impact on the cleaning machine's wiring system;

2. When placing it regularly, always pay attention to maintaining machine cleaning, and turn off the power when it cannot be used;

3. The cleaning machine equipment is not a collision resistant product, so it is necessary to avoid collision or severe vibration of the machine when using it;

4. The machine is not very good for electronic components and circuits under high temperatures, so it must be kept away from heat sources;

5. While keeping away from this heat source, prevent the machine from being placed in a damp environment;

6. The continuous running time of the machine cannot exceed 4 hours. If the continuous running time is too long:

7. For cleaning machines that have been running for a long time, before stopping, the power knob should be first set to zero, and the fan should be used to work for 3-6 minutes before shutting down to ensure the internal heat dissipation of the power supply;

8. The cleaning solution needs to be deposited, filtered, or replaced in a timely manner to ensure the cleaning effect.

To ensure the long-term normal operation of the system cleaning machine, in addition to avoiding non-standard operation, it is also necessary to regularly inspect and maintain the cleaning machine, and do a good job in the following aspects:

① Regularly clean the contaminated cleaning fluid in the oil storage tank.

② Run the oil pump on time for at least 10 minutes each time.

③ After using the cleaning machine, cover it with a cover to prevent dirt and moisture.