Preparations For Commissioning Ultrasonic Welding Machine

Preparations for commissioning ultrasonic welding machine

Before debugging the ultrasound welding machine, we need to do a lot of preparatory work. Generally, the technicians who deliver the machine to the door for the first time will install and debug it, but the customer should also know how to install and debug it. The following editor will explain the preparations that should be done before debugging the ultrasonic welding machine:

Installation environment.

1. The ultrasonic welder should be installed on a stable and firm worktable, because the ultrasonic welding will produce high-frequency vibration, and the equipment position may shift after long-term use. Installing on a firm worktable can avoid this situation.

2. The space where the ultrasonic plastic welding machine is used shall be far away from other heat sources such as heating equipment, and a 200mm gap shall be reserved behind the equipment and electric box to facilitate ventilation and line distribution. Because the energy conversion of mechanical equipment will produce heat residue (less heat residue), and the circuit board of electric box needs heat dissipation, the equipment shall be far away from the heat source as possible and pay attention to ventilation.

3. After placing the ultrasonic plastic welding equipment, we should start to connect the power (that is, plug the electric box and the welding machine). Before connecting the power, we need to determine the power supply voltage. Generally, the ultrasonic welding machine uses 220V power supply. If the power supply voltage is unstable, it needs to be equipped with AC power regulator.

4. The power supply of the ultrasonic welding machine has been grounded. If necessary, the copper screw at the back of the base can also be grounded. The grounding resistance shall not be greater than 4 Ω.

5. Next, connect the gas pipe to the air inlet of the air filter behind the equipment to ensure that the interface is sealed.