Jiayuanda Technology - The Method To Solve The Phenomenon Of Bursting Tendon Of Ultrasonic Sponge Scutter

1. When we collect more than one kilometer rolls of sponges with bursting tendons, when we roll about 300 meters, we change a roll of membrane with no problem before bursting tendons do not show. In this way, the burst tendon can not be shown, and it will not cause the stretching and deformation of the film, thus improving the rate of finished product.

2. When we use the sponge scutcher to cut the sponge with only two sides of bursting tendons, the kilometer roll is switched on the two sides of the reel when it receives about 300 meters before bursting tendons are not shown. When receiving 700 meters or so, then swap each other, so that the finished product volume will not appear the phenomenon of bursting tendons. Thus the loss is reduced and the yield of finished product is increased.

3. Generally, bursting tendons only occur in extruded products, and bursting tendons rarely occur in dry products.

4. Sprinkle a small amount of sanitary smooth spray powder when the swindling machine is rolled, which can also alleviate the phenomenon of bursting tendons.

Sponge slitting machine is currently divided into manual sponge slitting machine and CNC sponge slitting machine. Manual sponge slitting machine is cheap, but for sponge utilization ratio is low, and the operation is complex. CNC sponge slabbing machine is affordable, easy to operate, generally can use computer people can control, can effectively improve the utilization rate of sponge, and cut out no dust.