Preparation For Startup Of Ultrasonic Plastic Welding Machine

When starting the ultrasonic welding machine, the principle of turning on the air source first and then the power supply should be followed, because after connecting the power supply, some parts of the welding machine may have automatic operations such as reset. If the air source is not turned on, it is easy to cause equipment failure. After turning on the power supply, it is also necessary to turn on the grounding rotary button at the control box to ground, so as to make the use of the equipment safer. The second step is to turn off the ultrasonic test immediately after the power button is turned off. If the wavelength and amplitude displayed on the control box are normal, the ultrasound welding machine can be used normally.

If a wave of overload light of the ultrasonic plastic welding machine gives an alarm, it is necessary to check the fault point. The operator should first check whether the welding head is loose or cracked and whether the equipment base is loose. Then through the sound wave check button, people can eliminate the fault according to the detection prompt. If the sound wave of the ultrasonic welding machine needs to be adjusted, the corresponding button can be twisted on the control box to adjust its amplitude. After debugging the parameters, turn off the power and repeat the startup steps until the detection state of the ultrasonic plastic welder is normal.