Installation method of ultrasonic transducer

Tools: ARGON arc welding, no.10 hex key, ferrochrome tin cable, 2.5 square high temperature cable, 2 x 2.5 cable, vibration glue, (wire stripper, casing, tie tape, sandblasting machine, pipe fittings, etc.).

Welding screw: calculate the position of vibrator, weld the screw on the cleaned position, and then clean the screw around, be sure to make it smooth, so as not to affect the installation of vibrator.

Glue configuration: mix the glue evenly according to the specified proportion. (Meirui, Elaoda, 4030 glue mix before bonding, KMD398 glue mix in the bonding process).

Install vibrator head: glue evenly spread at the bottom of the ultrasonic vibrator, gently twist the air and excess glue between the bottom of the transducer and the bottom of the cylinder contact surface extruded out, so that the vibrator more closely combined with stainless steel as a whole.

Solidification and condensation: placed in a relatively high place at room temperature, 4-8 hours can be connected, 24 hours after the power test machine, the test machine must not allow air vibration.

note

1, metal nail machine can also replace argon arc welding. 2, welding screws must be fully welded, otherwise easy to fall off. 3, about curing, the length of time to consider the temperature, low temperature time is long, high temperature, a little faster, it is recommended to operate at room temperature, even if heating is not excessive heating, appropriate best.