Precautions for the initial use of ultrasonic plastic welding machine
May 20, 2022
1. Ultrasound uses 220V directly, so the body should be properly grounded before power on, and the grounding resistance should be less than 4 ohms.
2. When the mains voltage changes more than 10%, the machine shall be equipped with an AC voltage regulator to ensure the efficient and safe operation of the ultrasonic welding machine.
3. After power on, do not put your hand under the upper welding die to avoid high-frequency vibration and high-voltage damage.
4. When ultrasonic sounds, the upper welding die shall not contact the lower welding die, fixture and workbench to avoid damage to the parts.
5. Before ultrasonic welding, remember to do sound wave detection first, especially replace the welding die. This operation can not be neglected
6. Design, process and adjust the welding die, otherwise the ultrasonic energy exchange system of the welding machine will be damaged.
7. The pneumatic system is made of plastic products, and the applied external air source pressure shall not be greater than 0.5MPa, otherwise it will cause explosion or burn down.
8. Audible noise will be generated when the frequency drops during ultrasonic welding. The manufacturer of ultrasonic plastic welding machine suggests that long-term operators should wear ear protectors







