Function description of ultrasonic plastic welding machine components

Nov 02, 2022

1. Delay time setting: adjust the starting vibration time, and start to generate vibration 0~9.99 seconds after the limit switch acts.

2. Welding time setting: adjust the length of welding time, and generate vibration within the range of 0~9.99 seconds at the end of the delay time.

3. Setting of hardening time: adjust the cooling and setting time at the welding point of the working object after vibration generation to be within the range of 0~9.99 seconds.

4. Counter: used for recording the number of working cycles, with zero setting buckle attached.

5. Adjustment and pressure gauge: for indication of working pressure and adjustment of pressure.

6. Sound wave adjustment: adjust the resonance matching between the vibrator system and the generator circuit to achieve ideal conversion efficiency.

7. Amplitude meter: it indicates the amplitude of acoustic wave in no-load or load operation.

8. Power switch and lamp: control of power switch and signal indicating open circuit.

9. Selector switch (automatic/manual/acoustic inspection): automatic or manual selection, and button for acoustic no-load inspection.

10. Acoustic output adjustment button: used to set the number of acoustic output sections, sections 1 to 2 are for general use, and sections 3 to 4 are for strong output.

11. Acoustic overload lamp: it indicates that the acoustic overload is abnormal, and acoustic adjustment is required until the overload lamp does not display.

12. Frequency indication: display the ultrasonic welder machine frequency when debugging the ultrasonic plastic welder machine.

13. Welding head: drive the vibration energy on the working object to weld it.

14. Lifting/lowering buffer adjustment: the adjustment hole is located at the side of the ultrasonic welding machine table and can be adjusted properly to make the lifting inertia moderate.

15. Lowering speed adjustment: used to adjust the reasonable and appropriate lowering working speed.

16. Welding position window: check the condition of the welding head pressing the working object during normal welding.

17. Lowest trimming screw: It can be used to limit the drop of the cylinder when the melting block is welded or the overall dimension needs to be accurate.

18. Horizontal fine adjustment screw: adjust the four screws to make the welding head press evenly on the working object.

19. Output cable and socket: used to connect the ultrasonic vibration subsystem of the engine body and the line of the vibration generator box.

20. Control cable and socket: used to connect the body control unit and the automatic control circuit of the vibration ultrasonic generator box.

21. Grounding nut: used to connect the grounding wire of the electronic circuit, and to ensure safety in case of leakage.

22. Fuse holder: overload protection of electronic circuit.

ultrasonic plastic welding machine (3)