Precautions for single tank ultrasonic cleaner

In order to prolong the single tank ultrasonic cleaner service life, it is recommended to place the equipment in a ventilated and dry area, and the fan hole at the back of the generator should be cleaned regularly. Vents are reserved around the generator to make the air flow unobstructed. 

1. The cleaning tank can only be started up after liquid is put into it. The water level is more than 100mm (bottom vibration type) and it is placed horizontally. When the transducer is on the side, it is 100mm along the cleaning tank. If it is started up in the air state, the machine will be damaged.

2. When the temperature of the cleaning cylinder is normal, do not directly inject high-temperature liquid into the cylinder to avoid loosening the transducer and affecting the normal use of the machine.

3. When the cleaning fluid needs to be replaced due to pollution, do not directly inject the cryogenic liquid into the high-temperature cylinder, which may also cause the transducer to fall off. At the same time, the heater switch should be turned off to prevent the heater from being damaged due to no liquid in the tank.

4. Check the ultrasonic transducer regularly, and do not make it damp or hit, so as to avoid unnecessary loss. After use, turn off the main ultrasonic power supply. Do not restart the ultrasonic washer machine immediately after shutdown. The interval time should be more than 1 minute.