Are you clear about the safety management operation technical regulations of ultrasonic embossing machine?

1, according to the enterprise production technology design process management stipulated temperature, thirty minutes in advance of the embossed plate. Check if the three different temperature zones are the same as ours.

Before work, first check the power switch lifted from the operating table, check whether the safety barrier and emergency stop button are reasonable. When everything is a kind of automatic control switch does not work, can not start the work, in order to prevent the impact of personal safety accidents!

2. Install embossing board (or ironing plate) as required according to production procedure. Before installing embossing board (or ironing plate), all embossing board fixed by the enterprise (or ironing plate) should be input to all customers to remove, without hanging on the anchor mounting bolt to prevent damage to the embossing board (or ironing plate). When removing and replacing the wrench, we should not adjust the pressure too much.

3, the application of embossed plate, pay attention to the design personnel must be clean and clear. If there is environmental pollution, should apply relative solvent and fine copper wire brush to start painting. When standard is available, a high-pressure pump and boiling water can be used for cleaning. When cleaning ceilings, remove them from equipment and find an area with good natural ventilation to eliminate open fires and combustibles.

4. Ensure information security when changing the board. When the elevator goes to work, inform other board changing personnel to make sure that all personnel have their limbs off the operating table, and there are no other objects on the embossing board or ironing board. Before the application of electric forklift, check the learning situation in the work of electric forklift. In case of abnormality, maintenance must be carried out to prevent accidental injury or damage to embossing and ironing plates during the whole plate replacement process.

5, in the whole process of plate replacement, plate replacement personnel and equipment for actual work operation and management personnel must be at the construction site. In the whole process here, we should pay attention to the enterprise to prevent scratching the embossed plate. After changing the plate, when it is determined that there is no scratch on the embossing plate in the whole process of changing the plate, the personnel of changing the plate and the management personnel of the actual work of the equipment should sign on the record of changing the plate, and indicate the time of changing the plate (the time is in minutes as the standard). If you have a scratch, report it immediately. If there is a situation of concealment, in the next technology before the application of embossboard, by other enterprises actual work operation and management personnel found scratches, for the board personnel and before the application of the development of social research. Embossing board operator responsibility.

6, in addition to the work we need felt mat and rubber mat, not in the actual work can be placed on the table in addition to leather material products board all life objects.

7. Wear long-sleeved tops and work clothes, cufflinks or sleeves to work. You u don't have to wear rings, bracelets, bracelets and other accessories. Please leave an area for the device to work on when applying the phone.