Digital Ultrasonic PCB Driver

Digital ultrasonic PCB driver, also known as ultrasonic electric box, ultrasonic power supply, ultrasonic power control box and PCB type ultrasonic generator, which has mostly replaced manual cleaning at nowadays. It is suitable for electronics, hardware, circuit, electroplating, stainless steel, ceramics, lighting, automotive industry, tableware disinfection, precision instruments, optics and other industries, and that has the advantages of high efficiency, low cost, thorough cleaning No dead angle, strong practicability, etc.

The driver of Digital Ultrasonic PCB Driver generator has the function of frequency fine-tuning, and the adjustment range is 2%. The fine-tuning can be carried out under different working conditions, so that the ultrasound cleaning transducer can always work in the best state, and it achieve the maximum energy efficiency that with the best results under different working conditions.

The ultrasonic generator has the function of frequency sweeping. Through the ultrasonic frequency sweeping back and forth within a reasonable range during the cleaning process, the cleaning fluid is driven to form a fine reflux, so that the workpiece dirt can be quickly away from the workpiece surface while being stripped by ultrasonic, and the cleaning efficiency can be improved.

The digital ultrasonic PCB driver has the power adjustment function, and the output power can be continuously adjusted within the range of 10%-100% to meet the requirements of various cleaning objects.It can be divided into frequency adjustable ultrasonic generator, low-power ultrasonic generator, high-frequency ultrasonic generator, high-function ultrasonic generator and digital display ultrasonic generator.

Wiring instructions for circuit board and vibration head

1. The circuit board cannot be powered on without load

2. After installation, do not start the machine for more than 1 minute without any cleaning solution

3. The 60W drive board is a vibrator and is connected to the wiring post of the circuit board. 1 circuit board and 1 vibrator

4. The 120W drive board has two vibrating heads and is connected to the wiring post of the circuit board. One circuit board and two vibrating heads are used together

5. The 180W drive board has three vibrating heads and is connected to the wiring posts of the circuit board. 1 circuit board and 3 vibrating heads

6. Out + is connected to the positive electrode of the vibrator, and out - is connected to the negative electrode of the vibrator. When the positive and negative electrodes of out are respectively connected to the positive and negative electrodes of the vibrator, the power supply l of the drive board is positive and N is negative. The parallel drive plate Lb is a positive electrode and Nb is a negative electrode. Heating PTC is positive and N is negative. The display panel HT is an interface and the display panel J1 is a temperature probe interface. Remember not to get it wrong.

(Note: the voltage at the output end of the circuit board is about 400V, so be careful of electric shock. It is better to install a leakage proof protection switch on the input power supply to ensure safe use!)

For more details of Digital Ultrasonic PCB Driver, please feel free to contact us ！